Publications
NIBIOs employees contribute to several hundred scientific articles and research reports every year. You can browse or search in our collection which contains references and links to these publications as well as other research and dissemination activities. The collection is continously updated with new and historical material.
2022
Abstract
The occurrence of freeze–thaw cycles modifies water infiltration processes and surface runoff generation. Related processes are complex and are not yet fully investigated at field scale. While local weather conditions and soil management practices are the most important factors in both runoff generation and surface erosion processes, local terrain heterogeneities may significantly influence soil erosion processes in catchments with undulating terrain. This paper presents a field-based investigation of spatial and temporal heterogeneities in subsurface soil moisture and soil temperature associated with freezing, thawing, and snowmelt infiltration. The field setup consists of a combination of traditional point measurements performed with frequency domain reflectometry (FDR) and electrical resistivity tomography (ERT). The transect was approximately 70 m long and spanned an entire depression with a north-facing slope (average slope of 11.5%) and a south-facing slope (average slope of 9.7%). The whole depression was entirely covered with stubble. Observed resistivity patterns correspond well to the measured soil moisture patterns. During the observation period, the north facing slope froze earlier and deeper compared with the south facing slope. Freeze–thaw cycles were less pronounced in the north-facing slope than in the south-facing slope. There were also differences in soil temperature and soil moisture patterns between lower and upper parts of the monitored depression. These indicate that initiation and development of runoff related processes, and consequently soil erosion, in regions with freeze–thaw cycles may differ significantly depending on local terrain characteristics. Consequently, it indicates that spatial terrain heterogeneities, especially slope aspects, may be important when studying soil erosion processes, water flow and nutrient leaching in lowlands where patchy snowpacks and dynamic freeze–thaw cycles are predominating.
Abstract
Green roofs are increasingly being used to meet the challenges of extreme rainfall and surface water management in cities and towns. Biochar is a locally sourced and carbon-negative material that can be used as a substrate component for green roofs. Here are some experiences NIBIO has gained in this area through research and testing of various concept.
Authors
Cornelya Klutsch Simo Maduna Natalia Polikarpova Kristin Forfang Benedicte Beddari Karl Øystein Gjelland Paul Eric Aspholm Per-Arne Amundsen Snorre HagenAbstract
No abstract has been registered
Authors
Trine Eggen Heidi Amlund Robert Barneveld Aksel Bernhoft Gunnar Sundstøl Eriksen Belinda Eline Flem Torsten Källqvist Line Emilie Tvedt Sverdrup Stefan Trapp Anne Falk Øgaard Christiane Kruse Fæste Erik Jan Robert Lock Einar Ringø Håvard Steinshamn Robin Ørnsrud Åshild KrogdahlAbstract
Key words: VKM, risk assessment, Norwegian Scientific Committee for Food and Environment, Norwegian Environment Agency, potential toxic elements (PTEs), fertiliser, soil improver, fertiliser products, growing media, circular economy, circulation of organic fertilisers, arsenic (As), cadmium (Cd), chromium Cr(tot) (Cr(III) and Cr(VI)), copper (Cu), lead (Pb), mercury (Hg), nickel (Ni), zinc (Zn). Background and purpose of the report The potentially toxic elements (PTE) arsenic (As), cadmium (Cd), chromium Cr(tot) (Cr(III) and Cr(VI)), copper (Cu), lead (Pb), mercury (Hg), nickel (Ni) and zinc (Zn) occur as ingredients or contaminants in many fertilisers, soil improvers, engineered soil and growing media. Application of these fertiliser products might represent a risk towards the environment, farm animals and humans, particularly when applied annually over several years. The present risk assessment evaluates the application of selected fertilisers according to certain scenarios for representative Norwegian agricultural areas, from Troms in the North to Ås in Southeastern and Time in Southwestern Norway, with different soil properties, precipitation and PTE concentration in present agricultural soil. There is an increasing trend to produce locally (e.g. in urban farming) and home-grown vegetables that are cultivated in engineered soil and growth media. The maximum levels (MLs) set for PTEs in different organic fertilisers, engineered soil and growing media for use in urban farming, home growing and the cultivation of vegetables and garden fruits, and a set of MLs also for application in agricultural cultivation of crops, have been evaluated. Environmental fate processes and the transfer of PTEs have been modelled and the environmental risks for terrestrial and aquatic organisms, including from secondary poisoning have been estimated. Potential risks to humans and farmed animals by increased exposure to PTEs from, respectively, agriculturally produced crops, vegetables cultivated at home and urban farming or forage and grazing have been evaluated. The recycling of nutrients is urgently needed to achieve circular economy, but the derived sustainable products have to be safe, which requires the introduction of and adherence to science-based maximum levels of unwanted substances (e.g. pollutants). This assessment evaluates consequences of the application of different fertiliser products: mineral P fertilisers, manure from cattle, pig, poultry and horse, fish sludge, digestates and sewage sludge - in order to identify PTE sources with potential environmental, animal and human health risks, and to evaluate the appropriateness of the current MLs regarding different applications of organic-based fertilisers, engineered soil and growing media at present, and in a 100-year perspective. Approach and methods applied The approach for environmental and health risk assessments builds on previous work performed for hazardous substances in soil (e.g. VKM 2019, VKM 2014, VKM, 2009, Six and Smolders, 2014). Concentrations of PTEs in soil over time were calculated using a mass balance model, which considers the input by atmospheric deposition, use of fertilisers and soil improvers, as well as loss by leaching, run-off and plant uptake. The resulting first-order differential equation was solved analytically and implemented into Excel®. Run-off and loss by leaching were estimated from data on precipitation, infiltrating fraction and run-off fraction of the water under consideration of the distribution coefficient Kd for the concentration ratio of bulk soil-to-water. This Kd value takes aging sufficiently into account and is thus more realistic than those derived from batch tests. The Kd was estimated separately for each region using established regression equations, with soil pH, organic matter content and clay content as predictors. ...........
Abstract
No abstract has been registered
Authors
Randika K. Makumbura Miyuru Gunathilake Jayanga T. Samarasinghe Remegio Confesor Nitin Muttil Upaka RathnayakeAbstract
Hydrologic models are indispensable tools for water resource planning and management. Accurate model predictions are critical for better water resource development and management decisions. Single-site model calibration and calibrating a watershed model at the watershed outlet are commonly adopted strategies. In the present study, for the first time, a multi-site calibration for the Soil and Water Assessment Tool (SWAT) in the Kelani River Basin with a catchment area of about 2340 km2 was carried out. The SWAT model was calibrated at five streamflow gauging stations, Deraniyagala, Kithulgala, Holombuwa, Glencourse, and Hanwella, with drainage areas of 183, 383, 155, 1463, and 1782 km2, respectively, using three distinct calibration strategies. These strategies were, utilizing (1) data from downstream and (2) data from upstream, both categorized here as single-site calibration, and (3) data from downstream and upstream (multi-site calibration). Considering the performance of the model during the calibration period, which was examined using the statistical indices R2 and NSE, the model performance at Holombuwa was upgraded from “good” to “very good” with the multi-site calibration technique. Simultaneously, the PBIAS at Hanwella and Kithulgala improved from “unsatisfactory” to “satisfactory” and “satisfactory” to “good” model performance, while the RSR improved from “good” to “very good” model performance at Deraniyagala, indicating the innovative multi-site calibration approach demonstrated a significant improvement in the results. Hence, this study will provide valuable insights for hydrological modelers to determine the most appropriate calibration strategy for their large-scale watersheds, considering the spatial variation of the watershed characteristics, thereby reducing the uncertainty in hydrologic predictions.
Abstract
Three strains of chlorophyte microalgae indigenous in Norway were studied regarding their potential for nutrient removal and resource recovery from wastewater. The nutrient uptake, growth, and cell composition (total proteins and carbohydrates) were monitored under a controlled batch environment for 14 days. Additionally, the fatty acids were analyzed at the end of the study. The fastest nutrient removal was achieved by Lobochlamys segnis F12 that used up NH4+ (28 mg L-1) and PO43- (15 mg L-1) after 4 days. Similar PO43- uptake was achieved by Tetradesmus wisconsinensis H1 while its NH4+ uptake took 2 days longer. Both strains showed a higher specific growth rate (1.1 day-1) than Klebsormidium flaccidum NIVA-CHL80 (0.55 day-1). The highest biomass (1.276 ± 21 mg L-1) and carbohydrates content (40%) were achieved by T. wisconsinensis. K. flaccidum was characterized by superior protein content (53 ± 4%). In terms of total fatty acids production both K. flaccidum and L. segnis were favored (184 ± 6 and 193 ± 12 mg g-1 dry cells), especially with their high polyunsaturated fatty acid content (82 and 67%, respectively). The fatty acids of K. flaccidum consisted mainly C18:2 n-6 (73% of the total). L. segnis had a preferable n3 to n6 ratio (1.3) in their fatty acid profile. The proteins and carbohydrates content changed in all strains depending on the growth stage. Therefore, resource recovery scenarios could be further optimized for a specific cell component production combined with an appropriate strategy for nutrient removal from wastewater.
Abstract
No abstract has been registered
Authors
Daniel Rasse Simon Weldon Erik J. Joner Stephen Joseph Claudia I. Kammann Xiaoyu Liu Adam O'Toole Genxing Pan Nazli Pelin Kocatürk SchumacherAbstract
Background Biochar-based fertilizer products (BCF) have been reported to increase both crop yield and N-use efficiency. Such positive effects are often assumed to result from the slow-release of N adsorbed on BCF structures. However, a careful review of the literature suggests that actual mechanisms remain uncertain, which hampers the development of efficient BCF products. Scope Here, we aim at reviewing BCF mechanisms responsible for enhanced N uptake by plants, and evaluate the potential for further improvement. We review the capacity of biochar structures to adsorb and release N forms, the biochar properties supporting this effect, and the methods that have been proposed to enhance this effect. Conclusions Current biochar products show insufficient sorption capacity for the retention of N forms to support the production of slow-release BCFs of high enough N concentration. Substantial slow-release effects appear to require conventional coating technology. Sorption capacity can be improved through activation and additives, but currently not to the extent needed for concentrated BCFs. Positive effects of commercial BCFs containing small amount of biochar appear to result from pyrolysis-derived biostimulants. Our review highlights three prospects for improving N retention: 1) sorption of NH3 gas on specifically activated biochar, 2) synergies between biochar and clay porosities, which might provide economical sorption enhancement, and 3) physical loading of solid N forms within biochar. Beyond proof of concept, quantitative nutrient studies are needed to ascertain that potential future BCFs deliver expected effects on both slow-release and N use efficiency.
Abstract
Since 2020, the Norwegian Institute of Bioeconomy (NIBIO) Turfgrass Research Group has been studying agronomic, environmental, and economic consequences of switching to light-weight robotic mowers on golf course fairways and semiroughs. Preliminary results from field trials in 2020 and 2021 at the NIBIO Turfgrass Research Center Landvik, Norway, and demonstration trials on one golf course in each of the five Nordic countries, showed that turfgrass quality with robotic mowing was similar to manual mowing. At Landvik, robotic mowing resulted in less disease in both fairway and semirough but more infestation of white clover than manual mowing in the semirough. A survey of players’ attitudes to robotic mowers conducted on the five golf courses showed that about 90% of the players were positive or neutral to the new technology. However, respondents asked for better adaptation of the local rules on the golf course and even the international rules of golf to robotic mowing.